When it comes to gear reducers, I’m sure many friends are no strangers. Especially in recent years, with the improvement of production technology and gear reducer level, more and more types and models of gear reducers… There are also more and more applications. Inevitably, this problem occurs during the use of gear reducers. In order to solve these problems better, it is necessary to carry out some corresponding checks in order to eliminate the fault in time. The following sections will give you a brief introduction.
In the event of a gear reducer failure, it is also possible to check the condition of the gear reducer. Only by better following these conditions can you better check and repair. For example, when the gear reducer has a lot of noise, when the noise is very loud, the machine must be stopped to check if the gear reducer is unbalanced, which is what we often say on one side. Wear is particularly powerful. It is then necessary to replace the gear reducer in a timely manner.
In addition to the rolling sound, the fact that the gear reducer must be checked must also be taken into account. In general, the factors that cause the gear reducer to vibrate are also very large, in addition to partial damage, and then the components can also cause the gear reducer to oscillate when there is a problem with the ripples. Therefore, in order to better address these issues, timely investigations are also needed.
In addition, in order to better extend the life of the gear reducer, it is necessary to select the appropriate smoother during the use of the gear reducer. It should be noted that the selection of smoothers should be selected. It can be said that different types of smoothers have different effects on different types of gear reducers, rather than choosing more expensive smoothers. In order to better select the gear reducer, special attention needs to be paid to the details.
In addition, when checking the gear reducer, you also need to check the temperature of the gear reducer. Typically, the temperature of the gear reducer increases as the work increases, but after 1-2 hours, the temperature will be very stable. If the temperature of the gear reducer is found to be high during the inspection, the thermal capacity, cooling and speed of the gear reducer are also taken into account. No problem. If a problem arises, it needs to be resolved in a timely manner.
In general, in order to better extend the life of the gear reducer, it is necessary for professional and technical personnel to carry out better inspection and maintenance during the inspection.